Any accurate and high-end instrument will cause test errors due to the aging of parts, and the daily maintenance of the instrument becomes particularly important. However, the maintenance of the instrument can prolong its service life, but it cannot eradicate the problems caused by the aging of the parts. At this time If you replace the new instrument, it is a bit of a waste of resources; but if you continue to use it, it may cause more problems due to instrument errors.

The UV Aging Tester is a weather-resistant aging test machine that simulates the short light wave of the sun, rainy weather and humid climate with UV lamp, spray system and condensation system. Ultraviolet lamps are a type of light source that can generate ultraviolet light with a large effective range. It mainly simulates the ultraviolet light in the general light source in the real environment to test the lightfastness and antiaging properties of industrial products or raw materials such as rubber, silica gel, paint, coating, advertising, etc.

Precautions for operation of UV Aging Tester:

1. Non-fixed operation and trained staff of UV lamp weather resistance testing machine please operate at will.

2. Power supply equipment: an overloaded fuse device should be installed in the power supply line for this test box, and it should have a good grounding device.

3. Preparation of samples to be tested: After numbering the samples one by one, place the samples on the sample rack, and it is advisable that the products do not contact and collide with each other.

4. When everything is ready, close the door and then turn on the power, so as to cause too much ultraviolet rays to enter the body and cause skin cancer to the human body.

5. The weather-resistant test chamber should be placed in a well-ventilated indoor horizontal position, and flammable, explosive, and corrosive items should not be placed around it.

6. One iron-clad knife switch should be installed in the power supply line for the UV lamp weather resistance test box. Before the shell is grounded and electrified, please check the electrical performance of the box, and pay attention to whether there is an open circuit or leakage phenomenon. This test There is no explosion-proof device in the box, and flammable and explosive materials shall not be put into drying.

7. The items in the box should not be over crowded or overlapped, and a space must be left to facilitate the circulation of hot air and avoid test errors caused by being blocked.

Of course, different instruments have different processing methods. Through the above methods, our UV Aging Tester can be used for a longer time and the test is more accurate. Welcome to leave a message for more maintenance information of UV Aging Tester!